Lexmark C925 Service Manual page 87

Error code Action
58 Too Many Flash Too many flash options are installed. To continue:
Options
If this does not fix the problem, replace the RIP board. See
page
58 Too Many Trays
Attached
61 Defective Disk
62 Disk full
63 Unformatted disk
64 Unsupported disk
format
80 Fuser Near Life
Warning
80 Fuser Life Warning
80 Replace Fuser
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
4-46.
1. Turn off and unplug the printer.
2. Remove options until the supported number of options for that model. Models C925
supports three additional trays.
3. Plug in the printer, and turn it on.
• Select Continue to clear the message and continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue processing.
• Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Select Continue to clear the message and continue printing.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
Note: Be sure to reset the fuser count.
• If this does not fix the problem, replace the RIP board.See
page 4-46.
• Select Continue to clear the message and continue printing.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
Note: Be sure to reset the fuser count.
• If this does not fix the problem, replace the RIP board. See
page 4-46.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Replace the fuser. See "Fuser removal" on page
Note: Be sure to reset the fuser count.
• If this does not fix the problem, replace the system board. See
page 4-46.
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
"RIP board removal" on
4-51.
"RIP board removal" on
Diagnostic information
5041-030
Previous
Next
Go Back
2-55