Theta Sensor Removal - Lexmark C925 Service Manual

5041-030

Theta sensor removal

1.
Remove the LVPS. See
2.
Remove the 7 screws (A) securing the power box shield to the printer frame.
3.
Disconnect the theta sensor harness from the theta sensor.
4.
Remove the one screw (B) securing the theta sensor mounting plate to the printer frame.
5.
Remove the two screws (C) securing the theta sensor to the mounting plate.
4-48
Service Manual
"Low volt power supply removal" on page
D
C
4-42.
B
Previous
Next
Go Back