Angle/Depth/Height Adjustment Of The Footboard Assembly; Angle Adjustment; Depth Adjustment - Invacare Pronto M71 Service Manual

SECTION 7—FRONT RIGGINGS/FOOTBOARD
Mounting Hole
Quick Release
Pin
Detent Balls
FIGURE 7.9 Removing/Installing the Footboard Assembly
Angle/Depth/Height Adjustment of the Footboard
Assembly
Pinch point may occur when rotating the footboard assembly.

Angle Adjustment

NOTE: For this procedure, refer to FIGURE 7.10.
1. Loosen the jam nut and set screw
located underneath on the rear of the
footplate.
2. Adjust the mounting screw in or out to
obtain the desired angle.
3. Thread the jam nut and washer inward
until it is flush with the footboard
bracket.
4. Securely tighten the jam nut and
washer to secure the set screw in place.

Depth Adjustment

NOTE: For this procedure, refer to FIGURE 7.11 on page 73.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Pronto® M71™
All manuals and user guides at all-guides.com
Battery Frame
Footboard
Assembly
WARNING
72
Bottom view
Quick Release
Pin
Detent Balls
Outer Edge of
Tube
Set Screw, Washer and Jam Nut
Rear
Footboard Assembly
FIGURE 7.10 Angle Adjustment
Front
Part No 1118377