Using The 9100 In A System; Addressing The 9100 - Fluke 9100 User Handbook Manual

Final Width = 215mm
6-8 Section 6: 9100 System Operation — SCPI Language
6.4

Using the 9100 in a System

6.4.1

Addressing the 9100

6.4.1.1 Accessing the Bus Address
The instrument address can only be set manually; using the
is accessed via the Configuration menus.
N.B. A password is required for access to change the bus address.
6.4.1.2 Select 'Configuration' Mode
1. Press the Mode key on the right of the
front panel to obtain the 'Mode
Selection' menu screen:
2. Press the CONFIG screen key at the
center of the bottom row to progress
into 'Configuration' mode. The 9100
will transfer to the open 'Configuration'
menu screen:
6.4.1.3 Select 'MORE' Parameters
The bus address is one of the 'MORE' parameters. By trying to select 'MORE', the
'Configuration' password will be required.
Press the MORE screen key on the right of the bottom row. The 9100 will transfer
to the 'Password Entry' screen.
Bus Address menu, which
Mode Selection
Select required mode using softkeys
TODAYS DATE TIME
PROC MANUAL CONFIG CALIB TEST
Configuration
Ser. No. XXXXXX Rev. XXX
Present Settings:
Language English
Power-up mode Manual
Bus Address 1
Printer NONE
Results Card Disabled
Safety Voltage . V
Border Line 7 . %
Scope option Option 600
Crystal option High acc
TODAYS DATE TIME
V I E W M O R E