Fluke 9100 User Handbook Manual page 153

The 9100 first checks for the presence of the correct SRAM card. If there is no card in
the slot, if the card in the slot is not a SRAM card, or if it is a SRAM card but not write-
enabled, then the following screen is displayed:
Card slot test.
Insert a write enabled STATIC RAM
card into the selected slot.
(If no card in selected slot, or if
card not write-enabled, or if not a
TODAYS DATE
E X I T
After correcting the defect, press the OK screen key. This transfers to a new screen, and
the sequence of tests begins. The test in progress is reported on the screen:
The 9100 first checks the state of the card's internal battery. If the battery voltage is low,
this will be stated on the screen:
Card slot test.
Battery level is low.
TODAYS DATE
If there is no battery in the card, or if the battery cannot support read/write operations,
then the statement will be ' Battery level is dead.
Note:
For a re-chargeable card with a low battery, the low/dead message may take several
minutes to clear after pressing OK .
Section 8: Model 9100 — Routine Maintenance and Test
SRAM card)
TIME
O K
TIME
'.
Continued Overleaf
Final Width = 215mm
8-21