Interconnections - Fluke 9100 User Handbook Manual

Final Width = 215mm
6-6 Section 6: 9100 System Operation — SCPI Language
6.3.2

Interconnections

Instruments fitted with an IEEE 488
interface communicate with each other
through a standard set of interconnecting
cables, as specified in the IEEE 488.1
Standard document.
The IEEE-488 interface socket, J101, is
fitted on the rear panel. It accommodates
the specified connector, whose pin
designations are also standardized as
shown in Table 6.2
Pin
No. Name Description
1 DIO 1 Data Input/Output Line 1
2 DIO 2 Data Input/Output Line 2
3 DIO 3 Data Input/Output Line 3
4 DIO 4 Data Input/Output Line 4
5 EOI End or Identify
6 DAV Data Valid
7 NRFD Not Ready For Data
8 NDAC Not Data Accepted
9 IFC Interface Clear
10 SRQ Service Request
11 ATN Attention
12 SHIELD Screening on cable (connected to 9100 safety ground)
13 DIO 5 Data Input/Output Line 5
14 DIO 6 Data Input/Output Line 6
15 DIO 7 Data Input/Output Line 7
16 DIO 8 Data Input/Output Line 8
17 REN Remote Enable
18 GND 6 Gnd wire of DAV twisted pair
19 GND 7 Gnd wire of NRFD twisted pair
20 GND 8 Gnd wire of NDAC twisted pair
21 GND 9 Gnd wire of IFC twisted pair
22 GND 10 Gnd wire of SRQ twisted pair
23 GND 11 Gnd wire of ATN twisted pair
24 GND 9100 Logic Ground (internally connected to Safety Ground)
Table 6.2 Connector J101 - Pin Designations
12 1
24 13
Connector J101 - Pin Layout