Selecting The Automatic Restart Function - Omron NT11 - 01-2004 User Manual

Setting the Conditions of Communications with the PLC by Using the Memory Switches
3-7-3

Selecting the Automatic Restart Function

The "Auto-restart" memory switch is used to set whether or not the communi-
cation is automatically reset after the occurrence of a communication error.
The factory setting has been made at "No".
Select the Automatic Reset Function of the communication with the PLC by
the menu operation from the System Menu as mentioned below.
[System Menu]
Quit
Transmit Mode
Maintenance Mode
PT Setting
I/O Check
Initialize Memory
Memory Switch
[Memory SW1]
Backlight OFF: 10min
Auto-restart:
History Data:
To quit after setting the selection made, press the "ENTER" key. To quit with-
out setting the selection made, press any two function keys simultaneously.
• "Yes": If a communication error has occurred, corresponding error mes-
sage is displayed and the operation stops.
• "No": If a communication error has occurred, corresponding error mes-
sage will not be displayed and the operation will be automatically reset.
Select "Maintenance
1.0
Mode" with the
then press "ENTER".
Select "Memory Switch"
with the
"ENTER".
Select "Auto-restart" with
Page:
the
Pressing the [+/–] key
while "Automatic Reset" is
Yes
highlighted will cause the
Erase
selection for this item to
alternate between "No"
and "Yes".
Section 3-7
key,
key, then press
key.
75