Sony Handycam DCR-PC5 Operating Instructions Manual page 61

Dubbing only desired scenes - Digital program editing
To edit using the VCR, send the control signal by infrared ray to the remote sensor on
tile VCR.
When you connect using the A/V connecting cable, flollow tile procedures below, (1)
(4), to send the control signal correctly.
(1) Setting the IR SETUP code
@ Set the POWER switch to VCR on your camcorder.
@ Turn tile power of the cormected VCR on, then set tile input selector to LINE.
When you connect a video camera recorder, set its POWER switch to VCR/
VTR.
@ Press FN to display PAGE1 (p. 16).
@ Select EDIT SET in @ in the menu settings (p. 89).
Then press EXEC.
@ Select CONTROL then press EXEC.
@ Select IR, then press EXEC.
0 Select IR SETUP, then press EXEC.
@ Select the IR SETUP code of your VCR, then press EXEC. See the following
page about the IR SETUP code.
4
5
6-8
I OTHERS
_' EDIT SET
_'_ ADJ TEST
CUT IN'
CUT OUT'
r@ IR SETUP
I R TEST
OTHERS
'1_ ED I T SET
_t CO_'4TROL
ADJ TEST
[]_ PAUSEMODE
z CUT H'4
CUT OUT'
I R TEST
61