Sony Handycam DCR-PC5 Operating Instructions Manual page 57

Searching for a photo - Photo search/Photo scan
(1) Set the POWER switch to VCR.
(2) Press FN to display PAGE1 (p. 16).
(3) Press MENU, then set CM SEARCH in _ to OFF in the menu settings (p. 89).
(4) Press SEARCH MODE on the Remote Commander repeatedly, until the photo
search indicator appears.
The indicator changes as follows:
TITLE SEARCH ---* DATE SEARCH ---* PHOTO SEARCH ---* PHOTO SCAN
(5) Press _ or _ on the Remote Commander to select the photo for playback.
Each time you press _ or" IHH, your camcorder searches for the previous or
next photo.
Your camcorder automatically starts playback of the photo.
To stop searching
Press • on tile Remote Commander or on yore camcorder.
>
{D.
g
In the _ [ mark -'2
• Tile bar in the _ _211mark indicates the present point on the tape.
• Tile I mark in the _ indicates tile actual point you are trying to search.
If a tape has a blank portion between recorded portions o
Tile photo search f\mction n-lay not work correctly.
The available number of photos that can be searched usin 9 the cassette memory _'
Tile available number is tip to 12 photos. However, you can search 13 photos or
nlore
using the scanning photo f\mction.
(1) Set the POWER switch to VCR.
(2) Press SEARCH MODE on the Remote Commander repeatedly, until the photo
scan indicator appears.
The indicator changes as follows:
TITLE SEARCH ---+DATE SEARCH ---+PHOTO SEARCH ---+PHOTO SCAN
(3) Press I<1<1or _ on the Remote Commander.
Each photo is played back for about 5 seconds automatically.
3
1
To stop scanning
Press • on tlle Remote Commander or on yore camcorder.
57