Sony Handycam DCR-PC5 Operating Instructions Manual page 12

Step 1 Preparing the power supply
Charging temperature
The temperature range for charging is 32 °F to 104 °F (0 °C to 40 °C).
However, to provide maximum battery efficiency, tile recommended temperature range
when charging is 50 °F to 86 °F (10 °C to 30 °C).
If the power may go off although the battery remaining indicator indicates that
the battery pack has enough power to operate
Chmge the battery park fully again so that tbe indication oil the battery remaining
indicator is correct.
After charging the battery pack
Remove the battery pack fl'on-i the AC adaptor.
Note on NP-F10/FS11
The battery 1i% will be shorter when you carry out recording in a cold place or with the
LCD panel opened. We recommend that you use the NP FS21/FS31 large capacity
battery pack (not supplied).
Plug the power cord deeply
Be sure to plug the power cord deeply into the terminal of AC power adaptor so that it
is firmly locked. If there is a gap between the plug of power cord and the terminal of
AC power adaptor, it does not affect the efficiency of the AC power adaptor.
What is "lnfoLITHIUM"?
The "InfbLITHIUM" is a lithium ion battery park wbirh ran exchange data such as
battery consumption with compatible electronic equipment. This unit is compatible
with the "InfoLITHIUM" battery pack (S series). Your camcorder operates only with the
"InfbLITHIUM" battery.
"InfbLITHIUM" S series battery packs have the C'j)_._our._u_ Q mark.
InfbLITHIUM" is a trademark of Sony Corporation.
Install the battery pack to use your camcorder outdoors.
(1) While sliding BATT RELEASE in the direction of the arrow O, slide the
battery terminal covet" in the direction of the arrow _.
(2) Insert the battery pack in the direction of the arrow until it clicks.
2
12