HP StorageWorks XP20000/XP24000 - Disk Array Reference Manual page 360

• When you apply two or more settings at one time, the log information is output according to the
priority shown in Table
Apply, the log information is output as one entry.
If the priority is the same, the log information is output in the order of the operations performed.
• If you perform the following operations at the same time:
• Add > Delete: The operations cancel each other and no log information is output.
• Change > Delete: Log information is output for the Delete operation.
• Change 1 > Change 2: Log information is output for the Change 2 operation.
• Add > Change: Log information is output as an Add operation, but the contents of the setting
are output according to the setting of the Change operation.
• If you have deleted a host group, the following operations performed for that Host Group are not
output as log information:
• Changing host mode
• Changing Host Group
• Adding or deleting paths
• Adding, changing, or deleting WWN
2
When you apply two or more settings of the same type to the subsystem at the same time, the log
information is output as one entry.
3
When you set two or more port settings, the following conditions apply:
• When you perform two or more operations for one target, the log information is output as one
entry.
• The log information is output in the order of the operations performed.
• If you perform the following operations at the same time, the following happens:
Change 1 > Change 2: Log information is output for the Change 2 operation.
4
When one or more settings that you have applied at one time ends abnormally, the output log
information is Error, not Warning.
5
Indicates the operation when Fibre port is selected in the Authentication Tab.
6
When you set two or more LUSE settings, the following conditions apply:
• When you perform two or more operations for one target, the log information is output as one
log information file. For example, if you have created one LUSE volume and then created another
LUSE volume using the previously-created LUSE volume, the log information is output just as Make
LUSE.
• The log information is output in the order of the operations performed.
• If you perform the following operations at the same time, the following happens:
• Create LUSE volume > Delete LUSE volume: The operations cancel each other, and the log
information is not output.
• Create LUSE volume 1 > Create LUSE volume 2 > Create LUSE volume 3 using LUSE volume
1 and LUSE volume 2 > Delete LUSE volume 3: Log information is output only for the Create
LUSE volume 1 operation and Create LUSE volume 2 operation.
7
The log information is output at the end, no matter when you perform the Cache Residency Manager
operation.
360 Audit Log Information File Output by Function
313. When you perform two or more operations on one target and select