46 |
CH A P T E R 6 – TR O U B L E S H O O T I N G Y O U R S M ART BOARD 60 0I 3 OR SBD 600 I3
I N T E R A C T I V E W H I T E B O A RD S Y S T E M
System Warning Lights
ECP Ready Light and System Status
The ECP ready light is located on the ECP's main power button. This button also
functions as your status warning light.
Ready Light
Off
Solid amber
Flashing green
Solid green
Flashing amber
Projector Ready Lights and Projector Status
The UF55/UF55w projector's two indicator LED lights (Power and Temperature) are
located on the boom-mounted projector. Specific light sequences convey information
about the state of your projector, including warning messages and issues.
The following table describes projector warning messages and issues.
IMPORTANT
After you resolve your projector's issue, you must disconnect and then reconnect
your projector power cable, clear the indicator light sequence, and then reset your
projector's status.
Message
Idle mode
Powering
On (Lamp On)
Cooling
Status
The projector system isn't receiving power. Check your
power cord, RS-232 connector at the projector (located
below the power cable) and power supply. If nothing
changes after checking your power cord, RS-232
connector and power supply, call your
reseller.
The projector is receiving power but is turned off.
The projector is receiving power and is starting up.
The projector is on and the ECP is receiving power and
communicating with the projector.
Your interactive whiteboard system is about to enter
Idle mode.
Power LED
(Green/Amber)
Solid Amber
Flashing Green
Solid Green
Flashing Amber
authorized SMART
Temperature LED
(Red)
Off
Off
Off
Off