Flash Timing; Forward Campon; Group Listening; Handset Mute - Mitel SX-2000 EL Information Manual

SX-200 General Information Guide

Flash Timing

The Flash Timer is a system wide programmable item. Its value applies to all industry-standard
telephones in the system. The minimum flash timer is 200 ms. The flash timer can be
programmed from 200 to 1500 ms.

Forward Campon

Calls that camp on to a multi-line SUPERSET telephone can be selectively forwarded to the
telephone's call forwarding destination. When a party camps on to a busy telephone that has
call forwarding programmed (it may be active or inactive), the person at the busy telephone
can press a softkey or the FORWARD CALL feature key to forward that waiting party to the
call forwarding destination.

Group Listening

Group listening allows a user of a SUPERSET 4025, SUPERSET 4125, or SUPERSET 4150
telephone to carry on a conversation using the handset while allowing others nearby to listen
to the far end voice over the telephone set's speaker. The microphone is disabled in group
listening mode.

Handset Mute

This feature allows you to mute the handset microphone during an off-hook conversation. You
disable or enable the handset microphone during a conversation by pressing the HANDSET
MUTE key (toggle action).The Handset Mute feature is programmable on the SUPERSET 4015,
SUPERSET4025, and SUPERSET 4150 telephones.

Handset Receiver Volume Control

This feature enables the user of SUPERSET telephones to adjust the volume of the set's
handset receiver. The handset receiver volume is independent of the set speaker.

Handsfree Announce

When paging to a set that is in handsfree conversation, the paging set receives a burst of busy
tone. The paged set can press a "RESPOND" key to answer the page (the paging party has
no indication until the paged party speaks).

Handsfree Answerback to a Directed Page

This feature allows users of SUPERSET 4025, SUPERSET 4125, SUPERSET 4150,
SUPERSET 410, SUPERSET 420, and SUPERSET 430 telephones to respond handsfree to
a directed page. In order to respond to a directed page handsfree, the user must turn on the
set's microphone lamp in advance. Then, if a directed page is broadcast over the users set,
the set microphone is activated allowing the user to speak handsfree to the calling party.
Note that the SUPERSET 3DN and SUPERSET 4DN Auto-Answer for Directed Page Calls
feature provides a similar type of functionality for SUPERSET 3DN and SUPERSET 4DN
telephones.
158 Revision A 50003510