Diagnostics - Brady Tagus User Manual

5.2.7

Diagnostics

HEX DUMP MODE ♦
ENABLED
DISABLED
OPTIONS TESTING ♦
TEST PRESENT SENSOR
TEST CUTTER
PERFORM TEST
1 TIME
PRINT TEST RATE
000 (0-120)
SENSOR READINGS ♦
THR TRAN RIBM 24V PS HD RANK
255 255 255 255 255 255
RIBBON SENSOR LIMITS ♦
RIBBON ADC LOW HIGH
070 164
5-24 Rev A
Most commonly used for troubleshooting. Prints data and instructions
received from the host rather than interpreting them as label formats;
see Section 7.2.
Prints raw ASCII data received from the host rather than executing
the commands.
Executes and prints label formats (normal operating mode).
Allows or performs diagnostics of specific options within the printer.
Performs a functional test of the present sensor.
Performs a functional test of the cutter.
The test will cycle the selected number of times (1, 10, or 100) with
the results displayed following each attempt.
(min) ♦
The number of minutes to delay between the printing of batches of
Quick Test Labels.
Analog Sensor readings are displayed.
Live sensor values are displayed. Maximum values are shown in this
255
example, where:
THR = thermistor sensor;
TRAN = transmissive (gap) media sensor (REFL is shown if the
SENSOR TYPE is set to 'reflective');
RIB M = ribbon motion sensor;
24V = 24 volt DC power supply sensor;
PS = Present sensor;
HD = head-down sensor; and,
RANK = the value of the printhead ranking resistor.
Displays ribbon sensor ADC low and high values used for motion
detection.
Approximate default values are shown here (actual values will vary).
The Menu System