Media Sensor Adjustment - Brady Tagus User Manual

3.3 Media Sensor Adjustment

The Media Sensor needs to be positioned so that the printer can detect the presence of media
and the top-of-form (except for continuous stock, where the TOF is set through the front
panel).
To adjust:
1. With media loaded, as described in Section 3.2, grasp the Slide Tab and move the
Sensor Eye Mark into position over media according to the table below.
2. If loading media, return to the media loading instructions.
Media Type
Die-cut
Notched
Continuous
3-6 Rev A
Media Sensor Selection and Adjustment
Sensor Eye Mark Position
Near the middle of the label
Centered over the notch
Near the middle of the media
*
Sensing Required
Gap
Gap
Continuous
Media Sensor Adjustment