Brady Tagus User Manual page 86

Step Operator Action
7
Press the
8
FWD
Press the
9
Press the
Place the label under the Sensor
Eye Mark and lower the printhead
assembly.
11 Proceed according to your media
type:
•
Die-cut stock: strip media from
the backing and then reinsert it
into the sensor; adjust Sensor
Eye Mark over center of backing.
•
Notched stock : adjust Sensor
Eye Mark over center of notch.
•
Reflective stock: Adjust the
Sensor Eye Mark over the center
of the facedown black mark.
1. Press the
the setting and then record the
sensor reading in a table similar to
the one shown after Step 12, as a
TOF Value.
2. Next, press the
increment the Gain Number.
3. Repeat for each of the Gain
Numbers (00-32).
Note:
Do NOT move the position of the Media Sensor after it has been adjusted.
5-40 Rev A
Key.
ADVANCED ENTRY
SENSOR LEVELS
Key.
ADVANCED ENTRY
SENSOR GAIN
Key.
GAIN TRAN <yyy> *00
<0 - 31>
GAIN RFL <yyy> *00
<0 - 31>
GAIN TRAN <yyy> *00
<0 - 31>
Or for reflective media:
GAIN RFL <yyy> *00
<0 - 31>
Key to select
FWD
Key to
Displayed Message
- OR -
Comment
Press the Key to abort
this procedure.
You are beginning the
Advanced Entry Calibration.
If using preprinted media,
ensure the label area under the
sensor is free of preprinted text,
graphics or borders.
Where 'yyy' is a numerical
value representing the current
sensor reading: useful in
locating the best sensor
position.
Note: Never position the
sensor over a perforation
when recording a sensor
reading.
Quick Test Mode