Brady Tagus User Manual page 101

4. Slide the sensor eye mark (media sensor) into position over the center of the notch.
Note: The sensor eye mark may be indicated with either a groove or a white,
vertical line.
5. Calibrate the printer:
a. Hold the FEED button down until media begins advancing from the printer. The printer is
correctly calibrated if the message "Warning Low Backing" displays.
b. If the following error messages display, perform a full calibration: Cannot Calibrate, Top
of Form or Position Fault.
Note: If the label registration continues to drift, try placing the sensor eye mark
in the center of the media to register the label correctly (except for labels with a
die-cut hole in the center).
6. Press FEED a few times to advance the media.
BRADY T300 and Raised-Panel Labels 6-11 Rev A