Brady Tagus User Manual page 147

Configuration Using IP Discovery (DHCP, BootP, and RARP)
Once the Ethernet Print Sever has been installed and connected, p
Ethernet cable then turn the printer's power switch 'On'.
DHCP, BootP, and RARP are server services that provide a method for assigning and maintaining
IP addresses. The Print Server obtains IP information from this service.
The factory default has IP Discovery enabled. The Print Server makes IP requests at power-up. If
using this method of discovery, after the connection is established print a Configuration Label (see
below) from the printer to obtain the IP Address and then use it to install your printer port and
driver to complete your setup.
Note: Depending upon your server, you may have to wait a minute or two for the
assigned IP Address to appear on the Configuration Label.
To print a configuration label:
1. With the printer on, loaded with media (at
least 4 inches wide) and ribbon (if printing
with thermal transfer media).
2. Press the
FWD
button scroll to
'PRINT CONFIGURATION'
button again to print.
Once you have obtained the assigned IP from the configuration label you can then install the port
and printer driver using the Windows ® 'Add a Printer Wizard'. See section, Installing the Printer
Driver and Port in this document.
Optional Internal Ethernet Printer Driver
button once, then use the
and press the
lug in the power cord and
C-3 Rev A