Brady Tagus User Manual page 84

Step Operator Action
10 Exit upon successful calibration:
Back out of the menu tree by
repeatedly pressing the
Key.
If using gap or reflective media,
press and hold the
The printer will begin advancing
media; allow at least one label gap
(or mark) to advance under the
sensor.
Note: A 'Warning Low Backing' message indicates that the calibration was
successful with notched media or media on a transparent liner; see
Section 7.1 for details on this and other possible messages.
5-38 Rev A
Displayed Message
THU 11:34 a 25 MAR 2007
READY
Key.
Comment
The printer is now ready to
begin printing.
If this calibration was
unsuccessful, go to
Section 5.4.3.
Quick Test Mode