Diagnostics - Brady 2461 Operator's Manual

4.1.7

Diagnostics

HEX DUMP MODE
ENABLE
²DISABLE
OPTIONS TESTING
TEST PRESENT SENSOR
TEST CUTTER
PERFORM TEST
1 TIME
MONITOR GPIO INPUT
TEST GPIO OUTPUTS
PRINT TEST RATE
²0 (0-120)
SENSOR READINGS
THR TRAN RIBM 24V à
255 255
ß PS HD RANK
255 255
RIBBON SENSOR LIMITS
RIBBON ADC LOW HIGH
(MIN)
255 255
255
070 164
Most commonly used for troubleshooting.
Prints data and instructions received from
the host rather than interpreting them as
label formats; see Section 6.2.
Prints raw ASCII data received from the
host rather than executing the commands.
Executes and prints label formats (normal
operating mode).
Tests currently installed options
Performs a functional test of the Present
Sensor circuitry.
Performs a functional test of the optional
cutter mechanism and circuitry.
The cutter will cycle 1, 10 or 100 times
(selectable). The results of each attempt
will be displayed.
The number of minutes to delay between
the printing of batches of labels in Quick
Test Mode.
Analog Sensor readings are displayed.
Live sensor values are displayed. View
can be toggled with forward and reverse
keys. Maximum values are shown in this
example: thermistor sensor, transmissive
(gap) media sensor (TRAN is replaced
with REFL when the SENSOR TYPE is set
to 'reflective'), ribbon sensor, 24 volt
power supply sensor.
Present sensor,
printhead ranking resistor.
Displays ribbon sensor ADC low and high
values used for motion detection.
Approximate default values are shown
here (actual values will vary).
head down sensor,
53