Brady Tagus User Manual page 107

4. Adjust the applied pressure by turning the print-head pressure adjustment screws to achieve a
consistent print contrast across the media.
Note: To avoid removing the ribbon, carefully pull slack in the ribbon and move it
out of the way to reach the pressure adjustment screws.
Note: To prevent ribbon smudging when using narrow media, it may be
necessary to increase the pressure on the inner (closest to center plate) print-
head pressure adjustment screw.
5. Print a label and examine the printed image.
6. Press the FEED button until the label registers with the gap just forward of the print head.
Note: When changing label sizes, the printer may need to feed 2-4 labels to
register correctly.
7. Print another label. If the problem persists, readjust the print head leveling.
8. If the heat setting, print head leveling (cam) and/or print head pressure adjustments do not
result in consistent print across the label, it may be necessary to adjust the Print Head Burn
Line. See Section 6.3: Printhead Burn Line Adjustment
9. If ribbon wrinkle persists, the ribbon idler may require adjusting. See
Wrinkle Adjustment
Printhead Pressure Adjustment
.
.
Section 6.7: Ribbon
6-17 Rev A