Calibration Mode - Button Functions - Brady Tagus User Manual

4.7 Calibration Mode – Button Functions
In 'Calibration' mode, the buttons allow the printer to adjust to the media being used.
Calibration can be performed either automatically or manually, as detailed below.
Notes:
• Before calibrating, ensure that the Printhead Carrier Assembly is latched
down, that the cover is closed, and that the media sensor has been set for
the appropriate media type, see Section 4.5.2.
• Printer and cutter faults are disabled during
• If at any time you wish to discard your changes and revert back to the
previous calibration simply turn off power to the printer. Also, Factory
Defaults can be restored, see Section 6.7
To perform Calibration:
4-16 Rev A
, but can still occur while printing "test" labels.
and
Calibration Mode – Button Functions