Brady Tagus User Manual page 65

System Settings (continued)
FAULT HANDLING♦
LEVEL
STANDARD
VOID AND RETRY
NO REPRINT
VOID DISTANCE
0.50 in (.10-2.00)
RETRY COUNT
1 (0-3)
The Menu System
When a fault condition (ribbon out, media out, etc.) is detected, this
setting determines the level of intervention and the disposition of the
label being printed at the time the fault occurred.
Selects the printer's action, the action required by the operator, and
the label's reprint status.
Printing stops and a fault message is displayed. After the problem is
corrected, the FEED Key must be pressed to clear the fault. The label
in process is reprinted.
Depending upon the RETRY COUNT, one of the following actions
when faulted:
• If the Retry Count setting has not been exceeded, 'VOID' is printed
on the label in process and reprinting occurs automatically;
• If the Retry Count has been exceeded, printing stops and a fault
message is displayed. After the problem is corrected, the FEED
Key must be pressed to clear the fault. The label in process is
reprinted; or,
• If the CANCEL Key is pressed the operator now has the option of
canceling the reprint:
To allow the reprint, press the ESCAPE Key or to cancel the reprint,
press the ENTER Key (the operator now has the option of canceling
the entire label batch by pressing the ENTER Key again.)
Note: VOID will not be printed when insufficient space exists for
the height of the text (see VOID DISTANCE, below) or if the fault
occurred after the entire label was completed (i.e., when the label
reaches its Present Distance at or above the TOF).
Printing stops and a fault message is displayed. After the problem is
corrected, the FEED Key must be pressed to clear the fault. The label
in process is not reprinted.
Sets the distance to backup the faulted label to print 'VOID' on its
trailing edge, which also indirectly establishes the font size of the void
message.
Establishes the number of times the printer will attempt to reprint a
label. If the last label printed in this count has been voided, the printer
will stop and display a fault message.
5-19 Rev A