Brady Tagus User Manual page 120

Displayed Message
GAP MODE
FAULTY SENSOR
OUT OF STOCK
POSITION FAULT
PRINT ENGINE FAULT
RAM FAULT
REFLECTIVE MODE
CANNOT CALIBRATE
7-6 Rev A
Printer Fault Messages
Description
Consistently high sensor
readings were detected.
The printer cannot detect
media.
Two possible causes:
•
(1) The printer was
powered-off or reset during a
ribbon, out of stock or TOF
fault;
or
•
(2) the printer was unable to
complete the Media
Calibration.
The printer has detected a
problem within the print logic.
The system has detected a
RAM failure.
Consistently low sensor
readings were detected.
Fault and Warning Messages (Display Printers Only)
Possible Solution(s)
Press any key to continue. Ensure that media
was removed from the media sensor during
the appropriate calibration steps; also ensure
that no labels are stuck in the media sensor.
Retry the calibration. If the problem persists,
call for service.
Try the following:
Load media.
Readjust the Media Sensor over the TOF
mark; see Section 3.3.
If using media with large gaps, adjust the
Paper Out Distance; see Section 5.1.2.
Calibrate the printer; see Section
5.4.
Ensure that the labels are passing through
the Media Sensor.
Depending upon the cause:
•
(1) Press the FEED Key in an attempt to
identify and then clear the related fault
condition;
or
•
(2) if necessary, calibrate the printer; see
Section 5.4.
Try cycling the printer power 'Off' and 'On'. If
the fault does not clear, call for service.
Try cycling the printer power 'Off' and 'On'. If
the fault does not clear, call for service.
Press any key to continue. Ensure that the
reflective mark was inserted facedown in the
media sensor during the appropriate
calibration step; also, ensure that the
reflective mark is made of carbon based ink,
and that the sensor is free of debris. Retry
calibration. If the problem persists, try an
'Advanced Entry Calibration'; see
Section 5.4.3.