Brady Tagus User Manual page 67

Communications (continued)
NIC ADAPTER♦
IP ADDRESS*
SUBNET MASK*
GATEWAY*
SNMPTRAP DESTINATION
IP DISCOVERY
ENABLED
DISABLED
SET FACTORY DEFAULTS
HOST SETTINGS ♦
HOST TIMEOUT
10 SEC (1-60)
* Not available when "IP Discovery" is enabled.
The Menu System
Network Interface Card Adapter (optional). If not present, this displays
'NOT INSTALLED' when accessed. After making changes to these
parameters, save the changes, exit the menu system, the printer will
then reset for the changes to take effect.
The static IP address of the NIC Adapter. This is in standard dotted-
decimal format.
The static subnet assigned to the NIC Adapter.
Specifies the network gateway address the NIC Adapter should use.
Selects the Network IP address where all SNMP Traps will be sent. If
zeroed, no traps are sent. The Receiver must have SNMP service
installed.
This is the address discovery method used by the NIC Adapter if a static
address is not utilized. If no server for any of the discovery methods is
found, the static value specified is used.
Note: For faster NIC Adapter boot times, disable any discovery methods not
used.
Default. Modifications to IP, Subnet Mask, or Gateway addresses will not
be allowed.
WARNING! An IP Address assigned by a server has precedence
over any static IP Address stored in the NIC Adapter.
Disables IP Discovery.
Note: Select this option to ensure that any stored static IP is used by the NIC
Adapter.
Resets all of the network parameters to factory default settings, including
some parameters that are not accessible through the printer's menu.
Settings which affect all communications with a host.
The number of seconds a communications port must be idle before the
printer may process data from a different port. This value is also used to
"timeout" an image / label format download (i.e., if, at any time, data flow
stops before a complete label format is received, the data will be
ignored).
5-21 Rev A