Step By Step Modification Of The Printer Setup - Brady Tagus User Manual

4.5.3

Step by Step Modification of the Printer Setup

The following is an example of Printer Setup modification. Although this example will
detail how to modify the serial Baud Rate, the same method can be used to change any of the
printer's menu item settings.
Note: It is recommended that the Printer Setup Mode not be entered while
in Peel Mode or with the optional Present Sensor enabled. Depending on
label size this can cause unpredictable results.
1. With printer 'Off' and properly loaded with media, press and hold the
while powering 'On' the printer. Continue to hold the button until the
off, then release it.
2. Press and hold the
it. The following printout should be produced:
3. Press the PAUSE
printout should be produced:
4. At this point you will accept the current values for "test" and exit the Printer Setup
Procedure by simultaneously and briefly pressing the
until the STOP
Note: If you want to discard your changes and revert back to the previous
values simply turn off power to the printer before Step 5.
5. Now you can save your changes and resume
briefly pressing the
4-10 Rev A
FEED
button and count 7 flashes of the
button one time to increment to the 19200 bps value. The following
light goes off.
PAUSE
+ CANCEL
PAUSE
by simultaneously and
buttons. Wait until the
Printer Setup Mode - Button Functions
PAUSE button
light turns
STOP
ERROR
light, then release
+ CANCEL buttons. Wait
STOP light goes off.