Brady Tagus User Manual page 19

5. Close the Printhead Assembly and press down until it locks into place.
6. Close the cover and press the
proper tracking.
If the printer does not correctly sense the top of each label, as denoted by the
may be necessary to:
Printers without front display:Perform the Auto Media Sensor Calibration, see section 4.7.1.
Printers with front display:Press and hold the
mark is advanced then release. For additional calibration procedures, see section 5.4
Note: The printer is factory set to use 4-inch media (and ribbon, if thermal transfer
equipped). When using a different media/ribbon width, please refer to section 6.2.
Loading Media
FEED
button several times to position the media and ensure
FEED
button until at least one label gap or
light, it
ERROR
3-5 Rev A