Disabling Callhome - Cisco WS-C6506 Software Manual

Chapter 29 Configuring System Message Logging
This example shows how to verify the configuration:
Console> (enable) show logging callhome
Callhome Functionality:
Callhome Severity:
SMTP Server
-----------
172.20.8.16
Destination Address
-------------------
adminboss@cisco.com
adminjane@cisco.com
adminjoe@epage.cisco
From: adminjoe@cisco.com
Reply-To: adminjane@cisco.com
Console> (enable)

Disabling CallHome

When you disable CallHome, you do not clear any other of the CallHome parameters that are set. You
need to clear each parameter individually.
To disable CallHome on your switch, perform this task in privileged mode:
Task
Disable CallHome.
This example shows how to disable CallHome:
Console> (enable) set logging callhome disable
Callhome functionality is disabled.
Callhome messages will not be sent to the configured destination addresses.
Console> (enable)
To clear an address from the list of addresses that receive CallHome messages, perform this task in
privileged mode:
Task
Clear a destination address from the list of addresses that
receive CallHome messages.
This example shows how to clear the destination address adminboss@cisco.com from the list of
addresses that receive CallHome messages:
Console> (enable) clear logging callhome destination adminboss@cisco.com
Removed adminboss@cisco.com from the table of callhome destination addresses.
Console> (enable)
OL-8978-04
enabled
LOG_ERR (3)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring CallHome
Message Size
------------
No Fragmentation
No Fragmentation
128 bytes
Command
set logging callhome disable
Command
clear logging callhome destination
Email or Epage Address
29-15