Specifying, Displaying, And Clearing An Interface Alias; Configuring Snmpv3 On The Switch; Snmpv3 Default Configuration; Configuring Snmpv3 From An Nms - Cisco WS-C6506 Software Manual

Configuring SNMPv3 on the Switch

Specifying, Displaying, and Clearing an Interface Alias

You can specify, display, and clear an interface alias. The length of the alias can be up to 64 characters.
Note The set snmp ifalias command cannot be used in binary configuration mode. You must use the text file
configuration mode when entering this command or the interface alias is not saved in NVRAM.
To specify, display, and clear an interface alias, perform this task in privileged mode:
Task
Step 1 Specify an interface alias.
Step 2 Display the interface alias.
Step 3 Clear the interface alias.
These examples show how to specify, display, and clear an interface alias:
Console> (enable) set snmp ifalias 1 Inband port
ifIndex 1 alias set
Console> (enable)
Console> (enable) show snmp ifalias 1
ifIndex
---------- -------------------- ---------------------------------
1
Console> (enable)
Console> (enable) clear snmp ifalias all
Console> (enable)
Configuring SNMPv3 on the Switch
This section provides the basic SNMPv3 configuration information. For detailed information on the
SNMP commands that are supported by the Catalyst 6500 series switches, refer to the Catalyst 6500
Series Switch Command Reference publication.

SNMPv3 Default Configuration

Refer to the Catalyst 6500 Series Switch Command Reference publication for the SNMP default
configuration settings for each command that is listed in the configuration section.

Configuring SNMPv3 from an NMS

To configure SNMP from an NMS, refer to the NMS documentation (see the
section on page
The switch supports up to 20 trap receivers through the RMON2 trap destination table. You configure
the RMON2 trap destination table from the NMS.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
47-16
ifName ifAlias
sc0 Inband port
47-6).
Chapter 47
Command
set snmp ifalias {ifIndex} [ifAlias]
show snmp ifalias [ifIndex]
clear snmp ifalias {ifIndex} all
"Using CiscoWorks2000"
Configuring SNMP
OL-8978-04