Cisco WS-C6506 Software Manual page 1178

Configuring RSPAN on the Switch
Figure 49-3
Switch A
Table 49-2 Configuring a Single RSPAN Session
Switch Ports
A (source) 4/1, 4/2
B (source) 3/1, 3/2, 3/3
C (intermediate) –
D (destination) 1/2
Modifying an Active RSPAN Session
This example shows how to modify an active RSPAN session. Use
Table 49-3
an RSPAN session.
Table 49-3 Making Modifications to an Active RSPAN Session
Switch Action
A (source) Disable the RSPAN session.
B (source) Remove source port 3/2 from the RSPAN session.
B (source) Add back source port 3/2 to the RSPAN session.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
49-16
Single RSPAN Session
Switch D
1/1
T1
1/2
Switch C
3/1 3/2
T2
1/2
4/1 4/2 3/1 3/2
RSPAN VLAN
901
901
901
901
for the commands to disable an RSPAN session and to add or remove the source ports from
Chapter 49 Configuring SPAN, RSPAN and the Mini Protocol Analyzer
Destination switch
(data center)
1/2
Probe
Intermediate switch
(distribution)
T3
1/1
Source switch(es)
Switch B
3/3
Direction RSPAN CLI Commands
Ingress set rspan source 4/1-2 901 rx
Bidirectional set rspan source 3/1-3 901
– No RSPAN CLI command needed
– set rspan destination 1/2 901
RSPAN CLI Commands
set rspan disable source 901
set rspan source 3/1, 3/3 901
set rspan source 3/1-3 901
(access)
Figure 49-3 for reference; see
OL-8978-04