Uploading The Crypto Images To An Scp Server; Preparing To Upload An Image To An Scp Server - Cisco WS-C6506 Software Manual

Chapter 27 Working with System Software Images
Leaving power_on_diags
Cafe Daughter Present.
EOBC link up
Boot image: cat6000-sup720cvk9.8-3-1.bin
Flash Size = 0X1000000, num_flash_sectors = 64
readCafe2Version: 0x00000001
RIn Local Test Mode, Pinnacle Synch Retries: 2
Running System Diagnostics from this Supervisor (Module 1)
This may take up to 2 minutes....please wait
Cisco Systems Console
Enter password:
11/25/2003,13:52:51:SYS-5:Module 1 is online
11/25/2003,13:53:11:SYS-5:Module 4 is online
11/25/2003,13:53:11:SYS-5:Module 5 is online
11/25/2003,13:53:14:PAGP-5:Port 1/1 joined bridge port 1/1.
11/25/2003,13:53:14:PAGP-5:Port 1/2 joined bridge port 1/2.
11/25/2003,13:53:40:SYS-5:Module 2 is online
11/25/2003,13:53:45:SYS-5:Module 3 is online
Console> (enable)

Uploading the Crypto Images to an SCP Server

These sections describe how to upload the system software images from a switch to an SCP server:
•
•
Note For more information on working with the system software image files on the flash file system, see
Chapter 26, "Working With the Flash File System."

Preparing to Upload an Image to an SCP Server

Before you attempt to upload a software image to an SCP server, do the following:
•
•
•
OL-8978-04
Preparing to Upload an Image to an SCP Server, page 27-25
Uploading the Crypto Images to an SCP Server, page 27-26
Verify that the workstation acting as the SCP server is configured properly.
Verify that the switch has a route to the SCP server. The switch and the SCP server must be in the
same subnetwork if you do not have a router to route the traffic between the subnets. Check the
connectivity to the rcp server by entering the ping command.
If you are overwriting an existing file (including an empty file, if you had to create one), verify that
the permissions on the file are set correctly. The permissions on the file should be set to write for
the specific username.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Uploading the Crypto Images to an SCP Server
27-25