Cisco WS-C6506 Software Manual page 1313

Chapter 52 Configuring QoS
Selecting COPS as the QoS policy source switches the following values from the locally configured
values to the received COPS values:
•
•
•
•
•
•
•
Selecting the Locally Configured QoS Policy
To select the locally configured QoS policy, perform this task in privileged mode:
Task
Step 1 Select the locally configured QoS policy.
Step 2
Verify the QoS policy source.
This example shows how to select the locally configured QoS policy:
Console> (enable) set qos policy-source local
QoS policy source for the switch set to local.
Console> (enable) show qos policy-source
QoS policy source for the switch set to local.
Console> (enable)
Enabling Use of the Locally Configured QoS Policy
When enabled, COPS is the default QoS policy source for all ports. You can use a locally configured
QoS policy on a per-ASIC basis. To enable use of the locally configured QoS policy on a port ASIC,
perform this task in privileged mode:
Task
Step 1
Enable use of the locally configured QoS policy
on a port.
Step 2 Verify the QoS policy source for the port.
This example shows how to enable use of the locally configured QoS policy:
Console> (enable) set port qos 1/1 policy-source local
QoS policy source set to local on port(s) 1/1-2.
Console> (enable)
Assigning a Port Role
COPS does not configure the ports using the slot number and port number parameters. COPS uses roles
that you create and assign to the port ASICs.
OL-8978-04
All DSCP maps
Named and default ACL definitions
Microflow and aggregate policers
CoS-to-queue assignments
Threshold configuration
WRR weight and buffer configuration
Default port CoS and ACL-to-interface attachments
Command
set qos policy-source {local | cops}
show qos policy-source
Command
set port qos policy-source {local | cops}
show port qos
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
52-81