Snmpv1 And Snmpv2C Enhancements In Software Release 7.5(1) - Cisco WS-C6506 Software Manual

SNMPv1 and SNMPv2c Enhancements in Software Release 7.5(1)

This example shows how to define the community strings, assign a trap receiver, and specify which traps
to send to the trap receiver:
Console> (enable) set snmp community read-only Everyone
SNMP read-only community string set to 'Everyone'.
Console> (enable) set snmp community read-write Administrators
SNMP read-write community string set to 'Administrators'.
Console> (enable) set snmp community read-write-all Root
SNMP read-write-all community string set to 'Root'.
Console> (enable) set snmp trap 172.16.10.10 read-write
SNMP trap receiver added.
Console> (enable) set snmp trap 172.16.10.20 read-write-all
SNMP trap receiver added.
Console> (enable) set snmp trap enable all
All SNMP traps enabled.
Console> (enable) show snmp
RMON:
Extended RMON:
Traps Enabled:
Port,Module,Chassis,Bridge,Repeater,Vtp,Auth,ippermit,Vmps,config,entity,stpx
Port Traps Enabled: 1/1-2,4/1-48,5/1
Community-Access
----------------
read-only
read-write
read-write-all
Trap-Rec-Address
----------------------------------------
172.16.10.10
172.16.10.20
Console> (enable)
To disable access for an SNMP community, set the community string for that community to the null
Note
string (do not enter a value for the community string).
SNMPv1 and SNMPv2c Enhancements in Software
Release 7.5(1)
These sections describe the enhancements that have been added to software release 7.5(1):
•
•
•
•
•
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
47-12
Community-String
--------------------
Everyone
Administrators
Root
Setting Multiple SNMP Community Strings, page 47-13
Clearing the SNMP Community Strings, page 47-14
Specifying the Access Numbers for Hosts, page 47-14
Clearing the IP Addresses Associated with Access Numbers, page 47-15
Specifying, Displaying, and Clearing an Interface Alias, page 47-16
Disabled
Extended RMON module is not present
Trap-Rec-Community
--------------------
read-write
read-write-all
Chapter 47 Configuring SNMP
OL-8978-04