Disabling Unicast Flood Blocking; Displaying Unicast Flood Blocking - Cisco WS-C6506 Software Manual

Chapter 45 Configuring Unicast Flood Blocking
This example shows how to disable unicast flood blocking on a port:
Console> (enable) set port unicast-flood 4/1 disable
WARNING: Trunking & Channelling will be disabled on the port.
Unicast Flooding is successfully disabled on the port 4/1.
Console> (enable)

Disabling Unicast Flood Blocking

To configure the switch to receive the unicast flood packets on a port, you must enable unicast flood
blocking.
To disable unicast flood blocking, perform this task in privileged mode:
Task
Disable unicast flood blocking on the desired
Ethernet ports to enable unicast flooding.
This example shows how to disable unicast flood blocking on a port:
Console> (enable) set port unicast-flood 4/1 enable
Unicast Flooding is successfully enabled on the port 4/1.
Console> (enable)

Displaying Unicast Flood Blocking

To display unicast flood blocking information, perform this task in privileged mode:
Task
Display unicast flood blocking information per
port.
This example shows how to display unicast flood blocking information for port 1 on module 4:
Console> (enable) show port unicast-flood 4/1
Port
----
4/1
Console> (enable)
OL-8978-04
Unicast Flooding
----------------
Disabled
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring Unicast Flood Blocking on the Switch
Command
set port unicast-flood mod/port enable
Command
show port unicast-flood mod/port
45-3