Cisco WS-C6506 Software Manual page 1310

Configuring QoS on the Switch
This example shows how to display the QoS Layer 3 statistics:
Console> (enable) show qos statistics l3stats
Packets dropped due to policing:
IP packets with ToS changed:
IP packets with CoS changed:
Non-IP packets with CoS changed:
Console> (enable)
This example shows how to display the QoS aggregate policer statistics:
Console> (enable) show qos statistics aggregate-policer ag1
QoS aggregate-policer statistics:
Aggregate policer
--------------------
ag1
QoS aggregate-policer average rate statistics over 5 minutes:
Aggregate policer
--------------------
ag1
QoS aggregate-policer peak rate statistics over 5 minutes:
(collected every 30 seconds)
Aggregate policer
---------------
ag1
For PFC3B- or PFC3BXL-based switches, the peak allowed packet count rate will not be displayed. The
peak byte count rate will be displayed as shown here:
Console> (enable) show qos statistics aggregate-policer ag1
QoS aggregate-policer statistics:
Aggregate policer
--------------------
ag1
QoS aggregate-policer average rate statistics over 5 minutes:
Aggregate policer
------------------------------- ----------------
ag1
QoS aggregate-policer peak rate statistics over 5 minutes:
(collected every 30 seconds)
Aggregate policer
---------------
ag1
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
52-78
Total packets Average
---------------
621085
4495508
4495508
Allowed packet Packets exceed
count
--------------- ------------
2171253
Allowed packet
count
--------------- --------------
5399
Peak Allowed
rate (pps)
--------------
20802
Allowed byte
count
--------------
9992929900
Allowed rate
(kbps)
152080
Peak Allowed
rate (pps)
--------------
218912
Peak Rate
Rage(pps) (pps)
---------- --------
1289 3618
9937 18507
9937 18507
0 0
excess rate
411450
Traffic exceeding
excess rate
1024
Bytes exceed
excess rate
------------
2819929466
Traffic exceeding
excess rate (kbps)
------------------------
42911
Chapter 52 Configuring QoS
0
OL-8978-04