Cisco WS-C6506 Software Manual page 379

Chapter 14 Configuring MLS
This example shows how to display the CAM entries for a specified VLAN:
Console> show cam msfc 192
VLAN
----
192
192
Console>
Displaying MLS Information
The show mls command displays protocol-specific MLS information and MSFC-specific information.
To display protocol-specific MLS information and MSFC-specific information, perform this task:
Task
Display general IP or IPX MLS
information and MSFC-specific
information for all MSFCs.
1. The mod keyword specifies the module number of the MSFC; either 15 (if the MSFC is installed on Supervisor Engine 1 in
This example shows how to display IP MLS information and MSFC-specific information:
Console> (enable) show mls ip
Total Active MLS entries = 0
Total packets switched = 0
IP Multilayer switching enabled
IP Multilayer switching aging time = 256 seconds
IP Multilayer switching fast aging time = 0 seconds, packet threshold = 0
IP Flow mask: Full Flow
Configured flow mask is Destination flow
Active IP MLS entries = 0
Netflow Data Export version: 8
Netflow Data Export disabled
Netflow Data Export port/host is not configured
Total packets exported = 0
MSFC ID
--------------- ------ ---- ----------------- --------------------
52.0.03
Console> (enable)
OL-8978-04
Destination MAC
------------------
00-00-0c-07-ac-c0R
00-e0-f9-d1-2c-00R
slot 1) or 16 (if the MSFC is installed on Supervisor Engine 1 in slot 2).
Module XTAG MAC
15 1
Destination-Ports or VCs
------------------------------
7/1
7/1
Command
show mls {ip | ipx} [mod
Vlans
01-10-29-8a-0c-00 1,10,123,434,121
222,666,959
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring MLS
Xtag Status
---- ------
2 H
2 H
1
]
14-23