Configuring The Lcd Banner - Cisco WS-C6506 Software Manual

Configuring and Monitoring the Integrated Switch Fabric and Switch Fabric Module on the Switch
This example shows how to display the integrated switch fabric status and speed:
Console> show fabric status
Mod Speed
--- ----- -------
5
Console> (enable)

Configuring the LCD Banner

You can modify the LCD banner from the supervisor engine by entering the set banner lcd command to
include the following information:
•
•
•
•
•
•
After the LCD banner content is modified, this information is sent to the Switch Fabric Modules that are
installed in the chassis and displayed in the LCDs.
Note The set banner lcd command is not supported in the systems with an integrated switch fabric.
To modify the LCD banner content, perform this task in privileged mode:
Task
Step 1
Modify the LCD banner content.
Step 2
Verify the LCD banner change.
This example shows how to modify the LCD banner for the Switch Fabric Module:
Console> (enable) set banner lcd &HelloWorld!&
LCD banner set
Console> (enable) show banner
MOTD banner:
LCD config:
Hello
World!
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
46-12
Fabric
status
20G active
Chassis serial number
Switch IP address
System name
Supervisor engine version
Multilayer Switch Feature Card (MSFC) version on active and standby supervisor engine
System contact
Chapter 46
Command
set banner lcd c [text] c
show banner
Configuring the Switch Fabric Modules
OL-8978-04