Configuring Ip Device Tracking On A Port; Enabling Or Disabling Ip Device Tracking On A Port With 802.1X Authentication; Enabling Or Disabling Ip Device Tracking On A Port With Mac Authentication Bypass; Enabling Or Disabling Ip Device Tracking On A Port With Web-Based Proxy Authentication - Cisco WS-C6506 Software Manual

Chapter 43 Tracking Host Aging
To specify the probe interval, perform this task in privileged mode:
Task
Specify the time period in seconds to send a probe.
This example shows how to set the IP device tracking interval:
Console> (enable) set ip device-tracking probe interval 45
Device tracking probe interval set to 45 secs.
Console> (enable)
Specifying the IP Device Tracking Count
You can configure IP device tracking to send 1 to 10 probes after the host becomes idle. The default is
3 probes.
To set the probe count, perform this task in privileged mode:
Task
Specify the number of times to check for the existence
of a host.
This example shows how to set the IP device tracking probe count:
Console> (enable) set ip device-tracking probe count 5
Device tracking probe count set to 5.
Console> (enable)

Configuring IP Device Tracking on a Port

The following topics describe how to configure IP device tracking on a port:
•
•
•
•
OL-8978-04
Enabling or Disabling IP Device Tracking on a Port with 802.1x Authentication, page 43-4
Enabling or Disabling IP Device Tracking on a Port with MAC Authentication Bypass, page 43-4

Enabling or Disabling IP Device Tracking on a Port with Web-Based Proxy Authentication,

page 43-5
Enabling or Disabling IP Device Tracking on a Port with EoU, page 43-6
Command
set ip device-tracking probe interval
interval
Command
set ip device-tracking probe count count
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring IP Device Tracking on a Port
43-3