Qos Default Configuration - Cisco WS-C6506 Software Manual

QoS Default Configuration

Note •
•
For information on configuring QoS statistics data export, see the
Export" section on page
QoS Default Configuration
Table 52-3
Table 52-3 QoS Default Configuration
Feature
QoS enable state
DSCP Rewrite
Egress DSCP Mutation
Port CoS value
IntraVLAN microflow policing
CoS to internal DSCP map
(internal DSCP set from CoS values)
IP precedence to internal DSCP map
(internal DSCP set from IP precedence
values)
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
52-30
Per-port counter information and utilization statistics are not available for the ATM ports.
QoS statistics data export is completely separate from TopN and NetFlow Data Export and does not
interact with either of these features.
52-89.
shows the QoS default configuration.
Default Value
Disabled
Note—With QoS enabled and all other QoS parameters at the default values,
QoS sets Layer 3 DSCP to zero and Layer 2 CoS to zero in all traffic that is
transmitted from the switch.
Enabled
Disabled
0
Disabled
CoS 0 = DSCP 0
CoS 1 = DSCP 8
CoS 2 = DSCP 16
CoS 3 = DSCP 24
CoS 4 = DSCP 32
CoS 5 = DSCP 40
CoS 6 = DSCP 48
CoS 7 = DSCP 56
IP precedence 0 = DSCP 0
IP precedence 1 = DSCP 8
IP precedence 2 = DSCP 16
IP precedence 3 = DSCP 24
IP precedence 4 = DSCP 32
IP precedence 5 = DSCP 40
IP precedence 6 = DSCP 48
IP precedence 7 = DSCP 56
Chapter 52 Configuring QoS
"Configuring QoS Statistics Data
OL-8978-04