Displaying Ip Mls Cache Entries - Cisco WS-C6506 Software Manual

Configuring MLS
This example shows how to display IPX MLS information:
Console> (enable) show mls ipx
IPX Multilayer switching aging time = 256 seconds
IPX flow mask is Destination flow
IPX max hop is 15
Active IPX MLS entries = 356
IPX MSFC ID
--------------- ------ ---- ----------------- ----------------
22.1.0.56
22.1.0.58
Console> (enable)

Displaying IP MLS Cache Entries

These sections describe how to display the MLS cache entries on Supervisor Engine 1:
•
•
•
•
•
•
•
For a description of how the flow mask mode affects the screen displays when showing the MLS entries,
Note
see the
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
14-24
Module XTAG MAC
15 1
16 2
Displaying All MLS Entries, page 14-25
Displaying MLS Entries for a Specific IP Destination Address, page 14-25
Displaying IPX MLS Entries for a Specific IPX Destination Address, page 14-26
Displaying MLS Entries for a Specific IP Source Address, page 14-26
Displaying MLS Entries for a Specific IP Flow, page 14-27
Displaying IPX MLS Entries for a Specific MSFC, page 14-27
Displaying MLS Entries for Bridged-Flow Statistics, page 14-28
"Flow Mask Modes and show mls entry Command Outputs" section on page
Vlans
00-10-07-38-29-18 2,3,4,5,6,
7,8,9,10,11,
12,13,14,15,16,
17,18,19,20,66,
77
00-d0-d3-9c-e3-f4 25
00-10-07-38-29-18 26,111
00-d0-d3-9c-e3-f4 112
00-10-07-38-22-22 2,3,4,5,6,
7,8,9,10,11,
12,13,14,15,16,
17,18,19,20
00-d0-d3-33-17-8c 25
00-10-07-38-22-22 26,66,77,88,99,
111
00-d0-d3-33-17-8c 112
Chapter 14 Configuring MLS
14-9.
OL-8978-04