Cisco WS-C6506 Software Manual page 1323

Chapter 52 Configuring QoS
Enabling Per-Aggregate Policer QoS Statistics Data Export
To enable QoS statistics data export on a per-aggregate policer basis, perform this task in privileged
mode:
Task
Step 1
Enable QoS statistics data export per-aggregate
policer.
Step 2 Verify the configuration.
You must enable QoS statistics data export globally in order for the per-aggregate policer configuration
Note
to take effect.
This example shows how to enable QoS statistics data export for a specific aggregate policer and verify
the configuration:
Console> (enable) set qos statistics export aggregate ipagg_3 enable
Statistics data export enabled for aggregate policer ipagg_3
Console> (enable) show qos statistics export info
Statistics export status and configuration information
------------------------------------------------------
Export status: enabled
Export time interval: 300
Export destination:172.20.52.3 SYSLOG facility LOG_LOCAL6 (176), severity LOG_DE
BUG (7)
Port
------
1/1
1/2
3/1
3/2
5/1
5/2
<output truncated>
Aggregate name
--------------
ipagg_3
Console> (enable)
When enabled for a named aggregate policer, QoS statistics data export contains the following fields,
separated by the delimiter character:
•
•
•
•
•
•
•
OL-8978-04
Export
--------
disabled
disabled
disabled
disabled
enabled
disabled
Export
--------
enabled
Export type ("2" for an aggregate policer)
Aggregate policer name
Direction ("in")
Number of in-profile packets
Number of packets that exceed the CIR
Number of packets that exceed the PIR
Time stamp
Command
set qos statistics export aggregate name {enable
| disable}
show qos statistics export info
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
52-91