Cisco WS-C6506 Software Manual page 1099

Chapter 44 Configuring Network Admission Control
Enabling or Disabling EOU RADIUS Accounting
To enable or disable EOU RADIUS accounting, perform this task in privileged mode:
Task
Enable or disable EOU RADIUS accounting.
This example shows how to enable EOU RADIUS accounting:
Console> (enable) set eou radius-accounting enable
Radius Accounting for Eou Enabled.
Console> (enable)
Bypassing, Disabling, or Enabling LAN Port IP on a Per-Port Basis
You can bypass, disable, or enable LAN port IP on a per-port basis. Specifying auto mode enables LAN
port IP automatically if a client is found.
To bypass, disable, specify auto mode, or set the aaa-fail policy for LAN port IP on a per-port basis,
perform this task in privileged mode:
Task
Bypass, disable, specify auto mode, or set the
aaa-fail policy for LAN port IP on a per-port
basis.
This example shows how to enable an aaa-fail policy on a port:
Console> (enable) set port eou 1/2 aaa-fail-policy test_policy
Policy test_policy mapped as aaa-fail-policy on port 1/2
Console> (enable)
This example shows how to enable LAN port IP on port 5/1:
Console> (enable) set port eou 5/1 auto
EoU enabled on 5/1
Console> (enable)
This example shows how to set port 7/1 to bypass mode:
Console> (enable) set port eou 7/1 bypass
Eou Bypass enabled on 7/1
Console> (enable)
Initializing LAN Port IP on a Per-Port Basis
To initialize LAN port IP on a per-port basis, perform this task in privileged mode:
Task
Initialize LAN port IP on a per-port basis.
OL-8978-04
Configuring Network Admission Control with LAN Port IP
Command
set eou radius-accounting {enable | disable}
Command
set port eou mod/port {aaa-fail-policy | auto |
bypass | disable | initialize | revalidate}
Command
set port eou mod/port initialize
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
44-15