To Select The Programming Language - Agilent Technologies 34420A User Manual

Chapter 4 Remote Interface Reference

To Select the Programming Language

To Select the Programming Language
You can select one of three language to program the meter from the
selected remote interface. The language is
shipped from the factory. The languge setting is stored in non-volatile
memory and does not change with power off or reset. See also
"Programming Language Selection," on page 105.
On/Off
Shift < 1 Turn on the front-panel menu.
< < 2 Move across to the
< 3 Move down a level and then across to the
4 Move down to the "parameter" level to select the language.
Choose from one of the following: SCPI or KEITHLEY:181
Auto/Man 5 Save the change and turn off the menu.
The language selection is stored in non-volatile memory, and does not
ENTER
change when power has been off or after a remote interface reset.
Remote Interface: you can set the programming language using the
following commands:
SYStem:LANGuage {SCPI | 181}
L1X
L2X
192
A: MEAS MENU
I/O MENU
F: I/O MENU
5: LANGUAGE
SCPI
SCPI
choice on this level.
LANGUAGE
(SCPI)
(Keithley 181)
when the meter is
command.