To Set Or Change The Number Of Digits - Agilent Technologies 34420A User Manual

Chapter 2 Front-Panel Operation

To Set or Change the Number of Digits

To Set or Change the Number of Digits
You can set the display to show 4
book, the most significant digit (leftmost on the display) is referred to as
1 2
the " " digit, since it can only be a "0" or "1". The number of digits
displayed also depends upon the integration time set, see page 25.
Press the Shift key
Selects 5
(1 PLC)
The number of digits is set to 6
remote interface reset.
The number of digits shown is dependent upon integration time and
filter settings. The meter will not allow you to show more digits than
the practical measurement capability of the meter. You can, however,
reduce the number of digits shown.
1 2 1 2 1 2
, 5 , 6
1
Selects 7 digits
2
(100 PLC)
1
Selects 6 digits
2
(10 PLC)
1
digits
2
1 2
digits at power-on and after a
Fewer More
Digits Digits
1 2
, or 7 digits. In this
2
43