Agilent Technologies 34420A User Manual page 34

Chapter 2 Front-Panel Operation
Front-Panel Menu Reference
E: SYStem MENU
Ø
1: RDGS STORE 2: SAVED RDGS
Ø
7: CHART NULL 8: DISPLAY
1: RDGS STORE
2: SAVED RDGS
3: ERROR
4: TEST
5: CHART OUT
6: CHART SPAN
7: CHART NULL
8: DISPLAY
9: COMMA
10: PRESET
11: REVISION
F: Input / Output MENU
Ø
1: HPIB ADDR 2: INTERFACE
1: HP-IB ADDR
2: INTERFACE
3: BAUD RATE
4: PARITY
5: LANGUAGE
G: CALibration MENU *
Ø
1: SECURED [1: UNSECURED]
Ø
[5: INJECTED I] 6:CAL COUNT
1: SECURED
6: CAL COUNT
7: MESSAGE
* The commands enclosed in square brackets ( [ ] ) are "hidden" unless the meter is UNSECURED for calibration.
32
Ø Ø
3: ERROR 4: TEST
Ø Ø
9: COMMA 10: PRESET
Enables or disables reading memory.
Recalls readings stored in memory (up to 1024 readings).
Retrieves errors from the error queue (up to 20 errors).
Performs a complete self-test or individual self-tests.
Enables or disables the chart recorder output (Analog Out).
Sets the chart recorder output range (Analog Out).
Sets the chart recorder output offset (Analog Out).
Enables or disables the front panel display.
Enables or disables a comma separator between digits in the display.
Returns the meter to factory default settings.
Displays the meter's firmware revision code.
Ø Ø
3: BAUD RATE 4: PARITY
Sets the GPIB bus address (0 to 30, default 22).
Selects either the GPIB or RS-232 remote interface.
Sets the baud rate for RS-232 operation.
Selects even, odd, or no parity for RS-232 operation.
Selects interface language, either SCPI or Keithley 181.
Ø Ø
[2:CALIBRATE]
Ø
7:MESSAGE
The meter is secured against calibration; enter code to unsecure.
The meter is unsecured for calibration; enter code to secure.
1: UNSECURED
Performs a calibration of meter; must be UNSECURED.
2: CALIBRATE
Performs a calibration of the chart recorder output zero level.
3: CHART ZERO
Performs a calibration of the chart recorder output gain.
4: CHART GAIN
Performs a calibration to minimize the injected current.
5: INJECTED I
Reads the total number of times the meter has been calibrated.
Reads the first 11 characters of a calibration string, if any,
entered from the remote interface.
Ø Ø
5: CHART OUT 6: CHART SPAN
Ø
11: REVISION
Ø
5: LANGUAGE
Ø
[3: CHART ZERO] [4 : CHART GAIN]
Ø
Ø