Agilent Technologies 34420A User Manual page 58

Chapter 3 Features and Functions
General Measurement Configuration
Front Panel operation: Press
one of DIGITAL, ANALOG, or ANA + DIG . Press
filter type. Press the
To set the digital filter averaging, use the MEASurement menu
1: DIG FILTER command.
Remote operation: the following commands turn the filters off, on,
set the digital filter count, :
INPut:FILTer
:STATe {OFF|ON}
:TYPE {ANAlog | DIGital | BOTH}
:DIGital:RESPonse {SLOW|MEDium|FAST}
:DIGital:PRECharge {ON | OFF}
Using the filters in remote operation is not recommended. Use:
INPut:FILTer:STATe OFF
to disable the filters. The digital filter is also disabled following a
remote reset (*RST) or preset (SYStem:PREset).
Use the math operation (AVERage) commands to obtain a single
reading that is the average of a number of readings (see page 148). An
example program is shown on page 221 in chapter 6.
If you attempt to use the digital filter in remote operations, be aware
of the following special conditions:
The digital filter requires a number of readings to settle (10, 50 or
100). The digital filter readings only occur when the meter is triggered
to take a reading. In remote operation a reading is only taken when
requested. For example, if you have set the digital filter to MEDIUM
(50 readings), you will need to request (trigger) 50 readings from the
remote interface before the filter can settle. It is also possible that
after 50 readings the digital filter will still not be settled as described
in the next paragraph.
The STATus:OPERational:CONDition register contains a bit that
indicates the settled/unsettled state of the digital filter on a per
reading basis. See page 169 in Chapter 4. You should check the state
of this bit for each reading to ensure the digital filter count has not
reset (filter reset operation is described in the next section).
56
Shift Filter
Filter
key to turn the filter on or off.
and scroll to
Enter
to enable the