Installing The T1600 Router Mounting Hardware; Installing The T1600 Mounting Hardware For A Four-Post Rack Or Cabinet; Installing Cage Nuts, If Needed - Juniper T1600 Hardware Manual

CHAPTER 7
Installing the T1600 Router Mounting
Hardware

Installing the T1600 Mounting Hardware for a Four-Post Rack or Cabinet

Installing Cage Nuts, if Needed

Copyright © 2010, Juniper Networks, Inc.
Installing the T1600 Mounting Hardware for a Four-Post Rack or Cabinet on page 85
Installing the T1600 Mounting Hardware for an Open-Frame Rack on page 89
Installing Cage Nuts, if Needed on page 85
1.
Installing the Large Mounting Shelf on page 86
2.
Installing the Small Shelf on page 87
3.
4. Installing the Spacer Bars on page 88
Removing the Center-Mounting Brackets from the Chassis on page 88
5.
To install the cage nuts, if needed, in the mounting holes specified in Table 28 on page 85:
On the front rack rails, install cage nuts in the holes specified for the large shelf and
1.
the spacer bars.
On the rear rack rails, install cage nuts in the holes specified for the small shelf.
2.
The front-mounting flanges have holes for rack-mounting screws, spaced at 5.25 in.
(13.34 cm). Table 28 on page 85 specifies the holes in which you insert mounting screws
(an indicates a mounting hole location), and cage nuts if needed. The hole distances
X
are relative to one of the standard "U" divisions on the rack. The bottom of all mounting
shelves is at 0.04 in. (0.02 U) above a "U" division.
Table 28: Four-Post or Cabinet Rack Mounting Hole Locations
Hole Distance Above "U" Division
60 34.75 in. (88.3 cm)
51 29.51 in. (74.9 cm)
42 24.26 in. (61.6 cm)
Large
Shelf
19.86 U
16.86 U
13.86 U
Spacer Small
Bars Shelf
X
X
X
85