Required Tools, Wires, And Cables - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 HARDWARE GUIDE REV 9-29-2010 Hardware Manual

E120 and E320 11.3.x Hardware Guide

Required Tools, Wires, and Cables

46
Figure 25: E320 Router Rear Ports and Connectors
Cabling your system takes only a few minutes. You need the following items and those
listed in Table 6 on page 47 for proper installation:
1/8-inch flathead screwdriver
3/8-inch wrench or 3/8-inch nut-driver
No. 2 Phillips screwdriver
Ground wires—We recommend a minimum of 6-AWG ground wire.
Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground terminal.
PDU wiring—We recommend a minimum of 4-AWG wire for the router with a dual stud
terminal lug with 5/8-inch spacing.
Copyright © 2010, Juniper Networks, Inc.