Table of Contents
Advertisement
Step 4: Connect External Devices and Cables
Tools Required to Connect External Devices and Cables
Connect the ACX2200 Router to a Network for Out-of-Band Management
Connect the ACX2200 Router to a Management Console or Auxiliary Device
Connect Network Interface Cables to the ACX2200 Router
Copyright © 2016, Juniper Networks, Inc.
Figure 8: Ethernet Cable Connector
Tools Required to Connect External Devices and Cables on page 11
Connect the ACX2200 Router to a Network for Out-of-Band Management on page 11
Connect the ACX2200 Router to a Management Console or Auxiliary Device on page 11
Connect Network Interface Cables to the ACX2200 Router on page 11
To connect external devices and cables to the router, you need the following tools:
Ethernet cable with an RJ-45 connector attached (provided)
RJ-45 to DB-9 serial port adapter (provided)
Management host, such as a PC, with an Ethernet port (not provided)
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the
port on the front of the chassis.
MGMT
Plug the other end of the cable into the network device.
3.
Turn off the power to the console or auxiliary device.
1.
Plug the RJ-45 end of the serial cable
2.
the
port on the front panel.
CONSOLE/AUX
Plug the female DB-9 end into the device's serial port.
3.
Have ready a length of the type of cable used by the network ports. For cable
1.
specifications, see the ACX2200 Universal Access Routers Hardware Guide.
NOTE:
Shielded cables are required for outside deployment.
Remove the rubber safety plug from the cable connector port.
2.
Step 4: Connect External Devices and Cables
(Figure 8 on page 11
shows the connector) into
Figure 1 on page 4
shows the port.
(Figure 8 on page 11
shows the connector) into
Figure 1 on page 4
shows the port.
11
Advertisement
Table of Contents
