Required Tools, Wires, And Cables - Juniper E120 - RELEASE 11.1.X HARDWARE GUIDE 3-25-2010 Hardware Manual

E120 and E320 11.1.x Hardware Guide
Figure 25: E320 Router Rear Ports and Connectors

Required Tools, Wires, and Cables

Cabling your system takes only a few minutes. You need the following items and
those listed in Table 6 on page 49 for proper installation:
48

Required Tools, Wires, and Cables

1/8-inch flathead screwdriver
3/8-inch wrench or 3/8-inch nut-driver
No. 2 Phillips screwdriver
Ground wires We recommend a minimum of 6-AWG ground wire.
Two #10 kep nuts (supplied) to connect the ground (earth) wire to the ground
terminal.
PDU wiring We recommend a minimum of 4-AWG wire for the router with a
dual stud terminal lug with 5/8-inch spacing.